Quick and Easy PC Repair
If you see error code acpi bios rev 1008 on your computer, read these troubleshooting tips.
Messages: [email protected] …
> Does this mean I can boot or boot my IDE disk using SCSI?
> I have two IDE Promise Ultra100 TX2 ™ scsi controller boards. This
> It would be nice if I did this, but SCSI currently supports 7
> (see below) readers, is he likely to know what operating system each of our readers is running on?
> This is the coolest bios (I want!)?
> Comments please.
The Promise TX2 credit card is an IDE, not a SCSI, but it installs drivers via
Windows shows them SCSI like surfboards. I think this is a very strange Windows feature, for example
Calling directories “Folders”. Come on ? Often, They Linux specifies:
correctly as the IDE drives.
This is perhaps the most important setting in your BIOS that you can use to boot your cards.tx2. I currently have nothing to do with my system with two PIII 500 bottles,
System fully opens from the first hard drive on the first TX2 card, boots without flushing
all BIOS settings.
Now identify your readers. If you look at the sneaker screen and
If you write really well, do it – just kidding. Readers attached to cards can be
are recognized in the order in which each of our cards is in the system. If you look at
or motherboard, manual, PCI slots are marked with numbers. First location –
usually closest to the keyboard connector. Please refer to the buying guide. Map on a specific websiteThe smallest location is considered the first map. The cards continue
IDE1 and IDE2 are labeled relative to the board to which the cables are connected. So the firstThe reader will always be the primary reader connected to IDE1 on the first TX2 card.
In widow, drives are numbered Drive0, Drive1, and so on, while in Linux they are numbered. callsthen / dev / hde, dev / hdf, etc.
The system first downloads the TX2 reader to its system. This is not your
means that the operating system must be installed on this disk. Windows can change the theme at any time
Disk, but it requires a small boot partition on your m the current first disc. Linux on
Many others could be anywhere on the same type of disc. In one of two cases
The MBR (Master Boot Record) must be on the first TX2 disk.
It doesn’t really matter. When someone installs an operating system, it creates a
An option where you can install this tool and set up some kind of boot disk for you.
- Ask a meaningful question
Would You Like To Answer On This Channel Or Ask Your Question?
Looking for a username for a site, which usually only lasts a few minutes (here). After that, your family members can post your question, and the representatives of the human will can help you.
Download this PC optimization tool to make your computer run faster.